The galvanized lines produced by a good manufacturer saves money and effort, and how to do it?

The development prospects of galvanizing lines have always been very good, so there is also a problem. Some manufacturers only pay attention to development and do not pay attention to environmental protection. Therefore, the galvanized wire produced is not only polluting the environment, but also costing more. However, the galvanized line produced by a good manufacturer saves money and worry, and can also meet environmental protection standards. How is this done?

        First, the galvanizing lines consumes less energy. The galvanizing lines produced by a quality manufacturer guarantees the advantage of low energy consumption after one year of use. The reason for this is that the preheating temperature of the air is much higher than the temperature that is emitted from the chimney when you are in production. In this case, you can achieve a fuel utilization rate of about 80% in the production process. Think about it, the fuel utilization rate reaches such a high level, that is, the majority of the heat is given to the production process. Is the energy consumption of the stove that produces heat not low?

        Second, the operation of the galvanizing lines is relatively stable. The galvanizing lines produced by a good manufacturer can guarantee stable operation for a long period of time after being put into use. Generally, such a production line is rarely required to be maintained during use. With less maintenance costs, there is a lot of cost left.

        Third, the environmental standards for galvanizing lines are strictly controlled. Nowadays, the issue of environmental protection has attracted more and more attention from everyone. If you still pay attention to industrial development and do not pay attention to environmental protection as before, then if the EPA finds that your emissions are not up to standard, then the consequences It is also very serious, so it must be controlled from the source. For the substances emitted from the chimney, the content of sulfur dioxide and nitrogen oxides must not be too high. The galvanizing lines produced by a good manufacturer is in full compliance with the emission. standard.