What should I do if the flux is too much? | Fluxing Tank Reprocessing & Regenerating system

Most of them have some understanding of the welding work, but it is known that there is less need to add flux during the welding process. The Fluxing Tank Reprocessing & Regenerating system is more important in the welding process. The most common flux is Lead-free solder wire, what should I do if the flux is too much during the soldering process?

First, the Fluxing Tank Reprocessing & Regenerating system - play the extra flux

In fact, in the welding process, it is difficult to increase the amount of flux added, just a lot, not too much. If the amount of flux added is too small, it is easy to apply unevenly, and eventually the welding is unqualified, and the probability of occurrence of leakage welding, continuous welding, and virtual welding increases. Therefore, in order to ensure the quality of the solder, the Fluxing Tank Reprocessing & Regenerating system is often more or less, as much as possible, but if the flux is too much, it is easy to cause adverse effects, but special methods can be used to allow the excess flux to evaporate. portion.

Second, Fluxing Tank Reprocessing & Regenerating system- increase the temperature

The increase in temperature can increase the consumption rate of the flux, so the flux can be accelerated by increasing the temperature, or the time in the constant temperature zone can be extended, the Fluxing Tank Reprocessing & Regenerating system consumption time can be prolonged, and the flux consumption can be increased as much as possible.

Third, Fluxing Tank Reprocessing & Regenerating system - evenly spread flux

The product processing of the Fluxing Tank Reprocessing & Regenerating system needs to be strictly controlled. If the flux can be evenly distributed, the influence of the excess flux can be appropriately reduced. Therefore, the flux can be uniformly applied by adjusting the inclination of the solder.

In the welding process, if the flux can be strictly controlled, it is natural to improve the welding quality. It is important to control the Fluxing Tank Reprocessing & Regenerating system, but even if the flux is added too much, just take appropriate measures. no problem