What role does zinc pump play in hot dip galvanizing

In the whole process of hot dip galvanizing, a lot of equipment will be used, zinc pump is one of them, what role does zinc pump play in hot dip galvanization? Zinc pump, as the name implies, is the zinc fluid through the machine to pull out, when will be used zinc pump?

1. The process of hot dip galvanization is very complex and the equipment requirements are very strict, so the equipment should be maintained at intervals. If there is residual zinc solution in the galvanized pot, the zinc pump should be used.

2. If the hot dip galvanizing pot is found to leak during the process of hot dip galvanizing, it is convenient to repair the hole if the zinc solution in the hot dip galvanized pot is manually ladled out in ladle by ladle. Because zinc is metal, the density is much higher than water, and the zinc solution of galvanizing pot is very much, make worker bear the workload of high dynamic strength very hard, so need to use zinc pump at this time, such as saving time and high efficiency.

Warm tips: when using zinc-pumping pump, the appearance should be checked first; Secondly, when using zinc-pumping pump, when the zinc-pumping pump is electrically-rotating, the pump may not produce zinc immediately at the pump port. Third, in the process of zinc extraction, due to the drop in the zinc level, the zinc pump will also drop to ensure the depth of immersion. When it is necessary to stop the zinc pumping, the power of the zinc pumping pump must be disconnected first, and then the zinc pumping pump will be lifted out of the zinc level. Finally, the zinc pump should avoid collision, in case of the sun macroscopic use.