My status
Environment protection Zinc smoke enclosure exhausting & Filtering system Long use life made by Specified Steel material-GX08 highly accepted by hot dip Galvanizing Industry Fully enclosed pre-treatment room for Pickling, Rinsing, Fluxing, along with Acid mist collecting & Scrubbing tower system Siemens PLC Program Control system for complete hot dip galvanizing Production, automatic control and stable operation Expert in integrated Hot dip galvanizing production line supplier -Hebei Annuo Provide: Designing, Manufacturing, installation, Commission, Training.
Home / News / Some processing requirements of the small parts galvanizing lines are introduced

Some processing requirements of the small parts galvanizing lines are introduced

source: 07.06,2018 author:Hebei Annuo

In order to ensure the use of steel pipes, many of them are now galvanized, more stable application. small parts galvanizing lines, the production and processing also has many processing and requirements need to be considered, especially in the production environment, will directly affect the usage of steel tubes, the efficiency may also be affected. What should be considered in the actual production and processing?

small parts galvanizing lines

In the production line of small parts, the improvement of the production environment should be ensured first, including heating, ventilation and drainage. From the production line, should as far as possible to determine the temperature according to the production environment, to ensure good ventilation environment, drainage, etc. Also, must pay attention to make sure production environment clean and tidy, lest cause influence on pipeline processing.

Also need to consider in the practical production and processing to the application requirements of different pipe set, now of galvanized steel pipe is widely used, especially in some gas, heat pipes to use more, in order to guarantee the long time use of the pipeline, at the time of actual processing also should have different parameter Settings. Whether it is the material selection of steel tube or the technological proportion of steel tube, we should know and set it in advance to ensure the stable operation of the production line and the safety is well guaranteed.

small parts galvanizing lines of the major requirements and production line introduction, of course, in the actual production and processing of the time to have a comprehensive consideration, strictly in accordance with the relevant standards for production and processing, which can reduce production problems. This is necessary to have a good consideration for the processing operation, so as to avoid problems in production, better processing operation guarantee, and very good security.


small parts galvanizing lines Small Parts Galvanizing Equipment Hot Galvanizing Equipment
SHARE: My status
Hebei Annuo Automation Technology Co,.Ltd

TEL: +86-13703117050 +86-0311-68078187

FAX: +86-0311-84752998

WhatsApp: 0086 137 0311 7050

WeChat: 13703117050


ADDRESS: Shijiazhuang City,Hebei Province, 051530,China


ALL RIGHTS RESERVED © Hebei Annuo Automation Technology Co,.LTD. Technical support :